Family business since 1954
International branch
edwin.gomez@lutz-jesco.com
+44 (0) 2477 103306
Pump set mixing and pumping for solvents

Pump set mixing and pumping for solvents

Tauchtiefe:

Suitable for mixing and pumping of combustible and easily flammable liquids and for use in... more
with motor ME II 3 with low-voltage release, immersion depth: 1225 mmm (with mechanical seal)
suitable for container emptying Low voltage release prevents the pump from starting up again without warning after a power failure. Its recommended when pumping hazardous liquids.

Suitable for mixing and pumping of combustible and easily flammable liquids and for use in hazardous areas.

Liquid examples:
Easy flammable hydrocarbons, ethanol, butanol, isopropanol, kerosene, methanol, petroleum, etc. 

Features:

  • Two functions („pumping“ and „mixing and pumping“) in one unit
  • No grease fillings
  • Modular, service friendly design
  • Axial-flow rotor (R) for higher flow rates
  • Approved according to ATEX Directive 2014/34/EU, Category 1/2

Benefits:

  • Change between "pumping" and "mixing and pumping" without moving during operation via a small lever below the handwheel
  • High mixing performance and flow rate for thorough homogenisation and rapid drainage
  • Lube-free pump tube, thus no contamination of the liquid


Pump set consisting of:
Motor ME II 3 *, mixing pump tube SS 41-R-MS, 1225 mm in stainless steel, 2 m solvent hose 3/4" electrically conductive bound with hose connectors brass, nozzle brass / FEP, equipotential bonding cable.

* according to ATEX Directive 2014/34/EU, category 2

Note: The drum must always be covered during the mixing process.

Material: Stainless steel
Explosion Protection: explosion-proof
with motor ME II 3, 460 W (explosion-proof)* Immersion length: 1225 mm ...

with motor ME II 3, 460 W (explosion-proof)*

Immersion length: 1225 mm 
Temperature of medium: up to 100 °C
Flow rate:  up to 178 l/min. 
Pumping head:  up to 9 m wc 
Viscosity:  up to 200 mPas 

Specified values are maximum values determined with water at 20°C, measured directly at the pressure joint. Viscosity determined with oil. When using a nozzle the delivery rate is reduced to approximate values (see brackets).

* according to ATEX Directive 2014/34/EU, category 2